/* As is, all interrupts except reset jumps to 0xffff, which is most
 * likely not going to useful. To replace an entry, declare your function,
 * and then change the corresponding entry in the table. For example,
 * if you have a SCI handler (which must be defined with 
 * #pragma interrupt_handler ...) then in this file:
 * add
 *	extern void SCIHandler();
 * before th table.
 * In the SCI entry, change:
 *	DUMMY_ENTRY,
 * to
 *  SCIHandler, 
 */
extern void _start(void);	/* entry point in crt??.s */

#define DUMMY_ENTRY	(void (*)(void))0xFFFF

#ifdef _HC12
#pragma abs_address:0xffd0
#else	/* HC11 */
#pragma abs_address:0xffd6
#endif

/* change the above address if your vector starts elsewhere
 */
void (*interrupt_vectors[])(void) = 
	{ 
	/* to cast a constant, say 0xb600, use
	   (void (*)())0xb600
	 */
#ifdef _HC12
	/* 812A4 vectors starts at 0xff80, but most entries are not used 
	   if you use Key Wakeup H, change the start address to 0xffCE and
	   add one entry to the beginning */
	DUMMY_ENTRY,	/* BDLC */			/* Key Wakeup J */
	DUMMY_ENTRY,	/* ATD */			/* ATD */
	DUMMY_ENTRY,	/* RESERVED */		/* SCI 1 */
#endif
	DUMMY_ENTRY,		   			/* SCI */
	DUMMY_ENTRY,	/* SPI */
	DUMMY_ENTRY,	/* PAIE */
	DUMMY_ENTRY,	/* PAO */
	DUMMY_ENTRY,	/* TOF */
	DUMMY_ENTRY,	/* TOC5 */	/* HC12 TC7 */
	DUMMY_ENTRY,	/* TOC4 */	/* TC6 */
	DUMMY_ENTRY,	/* TOC3 */	/* TC5 */
	DUMMY_ENTRY,	/* TOC2 */	/* TC4 */
	DUMMY_ENTRY,		   			/* TOC1 */	/* TC3 */
	DUMMY_ENTRY,	/* TIC3 */	/* TC2 */
	DUMMY_ENTRY,		   			/* TIC2 */	/* TC1 */
	DUMMY_ENTRY,	/* TIC1 */	/* TC0 */
	DUMMY_ENTRY,					/* RTI */
	DUMMY_ENTRY,	/* IRQ */
	DUMMY_ENTRY,	/* XIRQ */
	DUMMY_ENTRY,	/* SWI */
	DUMMY_ENTRY,	/* ILLOP */
	DUMMY_ENTRY,	/* COP */
	DUMMY_ENTRY,	/* CLM */
	_start			   	   	   	   	   /* RESET */
	};
#pragma end_abs_address